Double Sheets Folder Gluer

Main Introduction

High speed folder gluer can be used for box making by double sheets as AA sheets or AB sheets or single sheet. It can replace manual pasting, reduce labor intensity, save a lot of labor and can greatly improve product quality.

Main technical characteristics

This machine adopts double servo feeding, ensure machine stability and synchronization at high speed, and feeding size of A and B products can be set separately, to solve the problem of big and small sheets feeding trouble. Middle glue unit adopts double pasting, hot melt glue and sealing glue, ensure 100% strong gluing when products in container and cold storage. Double servo motors are used when positioning, supply same precision both in low and high speed. This machine can produce flat box and shaped box, the front gauge positioning is original designed by our company, dual-use system is used to save time for adjustments. This machine is a dual-purpose machine, both double sheets and single sheet can be produced, it takes only two minutes to convert double sheets to single sheet.

Parameter and configuration

Paper size(Single sheet) Max.1200*1200 Min.500*370
Suitable paper A-E corrugated board and ≤6mm 5 ply cardboard
Speed 3200sheets/h
Machine dimension 9660*4500*1400(B model)
Total weight 3.3T
Total power 9 kw

Configuration

Installation and operation attentions

Installation and wiring

• This machine weighs 8T, it is not high on the ground, it needs 10cm thick cement floor, but it requires relatively good surface flatness.
• When the machine is installed, the drive surface must be about 1m away from the wall for operation and daily maintenance.
• The input power of this machine is 380V ac power supply, with zero line and ground line, please follow the wiring diagram.Be sure to install the ground wire!!!
• The air pressure reached 0.6mpa before operation, operation method: First turn on the power of the machine,then turn on the power switch on the button board, in the parameter setting of the touch screen, input parameters such as paper parameters and suction length, etc, then press the power-on button, operation button, blower switch, then machine can be started, check whether all the movements and functions of the machine are normal, it can be started if normal.
• The temperature controller is the controller that heats the hot melt glue, when working normally, set the temperature, choose the automatic way to carry on the

If you go to work the next day, you can heat it manually in advance, or you can use the automatic setting for pre-heating.

Operating items

• The machine must be started after melting of hot melt
• According to the size and thickness of the paper, to adjust the position of side gauge, suction belt and feeding knife pressure, ensure the continuity and smoothness of the
• Turn on the fan, transfer paper into the middle part, then adjust the paper belt position according to paper size, and then adjust the side push
• Add glue into the bucket, adjust the control knob according to the glue and paper properties, so that it can reach the amount of glue needed at

Daily maintenance 

• Each connecting rod mechanism should be added lubrication oil
• Each bearing should be added lubrication oil
• The bearing of the hot paste drum needs to be added high temperature grease (temperature resistant to 250℃).
• Wipe the machine regularly, especially before the adjustment the middle part, it need to wipe the six square shaft and the optical axis, to avoid dust accumulation, influence regulation.
• Wash the bucket